Henderson "PATTERN ie non genuine" garage door handle will fit all Henderson doors Inc Merlin and Doric

Choice of 18mm or 34mm spigot mounting points - These are the raised mounting points on the back.

Choice of shaft lengths 25mm, 57mm or 78mm (the long one can be cut down to suit other shorter lengths)

Choice of Silver, Black (Black in long shaft long spigot only)

Spigot mounting is at 50mm centers Comes with 2 x keys, gasket and mounting screws

Spindle is diamond 45 degrees to the handle

Locks in open or close position and therefore can be used clockwise or anticlockwise

Also available separately: Fixing screw kit & gasket

Please note: This is a generic “Pattern” part and is made to replace similar locks for the Henderson range of garage doors. The mounting screws may need to be cut down on some styles of door and the shaft can be cut down to length required and therefore is NOT drilled on the end.  The pack of screws, washers and split pin should cover all requirements. If you are trying to fit this to another make of door then the fittings may not be suitable, please ask at time of order and I will try and "tailor make" you a set of fittings.