Marshall Comp II LED 5" 6-Gauge Set

Set includes:

  • 5" Electric Programmable Speedometer, 0-160 MPH
  • 5" Tachometer, 0-10,000 RPM
  • 2-1/16" Volts, 8-18V  
  • 2-1/16" Oil Pressure, 0-100 PSI with sender
  • 2-1/16" Water Temperature, 120-280F with sender
  • 2-1/16" 5 Range Fuel Level, Empty-Full.  Works with 0-90, 73-10, 240-33, 0-30 or 20-150 ohm senders.

Why Buy From Us?

  • We double check each gauge for correct operation before packing your order.  This process includes putting signals to all gauges to verify correct operation.
  • We verify no accessory items are missing (u-clamps, bulbs, senders etc) .
  • We photo document your order to ensure completeness.
  • Fast shipping
  • "No hassle" extended warranty.  If you buy from us and have an issue with a gauge just send it back and we'll replace it, even it is more than 1 year later.   

Features:

  • High quality gauges made in Orange County, CA USA.
  • High-speed full sweep stepper motor speedometer and tachometer
  • Short sweep electric stepper motor 2-1/16" gauges 
  • Electric programmable speedo with one-step easy calibration and 2 Trip meters
  • Fuel level gauge available in 5 different ranges (*see below for more info)
  • White through-the-dial LED lighting for easy viewing at night
  • 3D glowing pointer for easy visibility at night

Why pay $780+ for a comparable Auto Meter Sport-Comp II gauge set?


    Through-Dial LED Lighting
    This set features white through-the-dial LED lighting and glowing 3D pointer for a cool look and easy viewing at night.

    Made in the U.S.A.
    This item is made in California, USA.  Please allow 1-2 days for your item to be made before it ships.

    Frequently Asked Questions

    Are sending units included?
    The oil pressure and water temp sending units are included. 

    The volts gauge does not require a sender. 

    A fuel level sender is not included.  The fuel level gauge will work with any of the following fuel level sending units: 0-90 ohm, 73-10 ohm, 240-33 ohm, 0-30 ohm or 20-150 ohm.  

    Speedometer will work with any OEM or aftermarket speed sensor or electronic module that meets the following conditions:

    1. Pulse range generated proportional to the vehicle speed
    2. Signal with minimum 3V peak to peak signal - typical for 3-wire hall effect and 2 wire vehicle speed sensor outputs
    3. output of 4,000 to 200,000 pulses per mile (most senders are 16,000 ppm)

    If you currently have a mechanical speedometer (cable driven) you will need a hall effect sender.  See the "Accessories" section of our eBay store add a hall effect sender to your order.  The hall effect sender installs on your current transmission cable take off location. The signal from the hall effect sender (12V Square Wave signal) drives the electric speedometer. 

    The tachometer does not require a sender - you get the signal from the coil (-) or other tach signal source (i.e. ECU or Tach output on HEI or ignition box).

    TERMS & CONDITIONS
    1 year warranty.  30 day return policy.  See terms and conditions for this item here: Terms & Conditions.

    Check out our other gauge set listings including our C2 Blueline with cobalt blue accents, C2 Redline with red accents and full sweep electric SCX gauge sets.

    Updated: 3/1/2023