Current Fixed Version and please do not compare our item with other  low  quality Made in China products

Green

FOR

● Compatibility List in Ebay is just a reference,  there are more compatible cars are suitable for this bulb, buyer still has  the

   responsibility to check the exact socket.

● This BA15S LED  Replacement:1156 1073 1093 1129 1141 1159 1295 1459  1619  1651 1680 7506 7527

● CUSTOMER DESIGN AVAILABLE FOR OTHER BASES or COLORS PLEASE CONTACT US

● Make sure item SIZE (Width &  Length  indicated in photo of description) and Voltage

● High  Brightness

● Emitted  Color: Green

● DC 12V for replacing regular Parking Light / Indicator Light / Direction Indicator /  Third  Stop / Rear Light /

   Stop Light / Signal Turn Light / Day Running Light / Tail Light  (May Vary depending on the vehicle  models  )

● Long life  span

● Plug and work  directly

● Base :

1156 BA15S (BAYONET Single Contact Aligned Pins) 

● Endurance  Voltage  Range: 10~18V

● LED current  regulator  added please do not compare our item with other low quality Made in  China  products

● LED Type: 5050 SMD  3  Chips in one LED

● LED Qty: 20PCS (60  Chips) TOP:6 PCS; SIDE: 2 PCS x 7  STICKs

-- DASH BOARD ERROR MESSAGE --

This LED Light may Not work properly  on  latest/European cars with OBC Canbus wiring system  (shows Error message)

Please be advice that many modern luxury cars which computer built in have sensors

built  into  the dashboard computer system that can detect if light bulb works.  However  the purpose to use LED BULB is

energy saving, which means the car  computer will misjudge the LED BULB not work because of the low wattage  to  lead the

error signal showed in your  dashboard.  Basically the bulb can be judged OK when the wattage goes up to 5 Watt  and  above,

all LED BULBs themselves have nothing to  do  with this problem except you install resistor to enlarge the wattage

-- HYPER FLASH SPEED FOR SIGNAL/TURN  LIGHT  APPLICATION--

Normally when you flip your turn signal switch, the light blinks at a set,  slow  pace. However, if you have modified your lights

to  use  LEDs, you'll notice that the turn signals now blink very quickly. This is  caused  by the low resistance of the LEDs due to

the  fact  that they use less energy. To correct the problem, you'll need  to wire the turn signals in a parallel circuit.

To  do  this, you'll be installing a resistor or  control  flasher.

● Quantity: As  Title  Indicates

● We use ANTI- STATICS  ELECTRICITY BAG to pack your order but not LOW-QUALITY BLISTER  CARD  unless mentioned by the

    buyer.  (Do you know that LED is Electrical Component and ANTI-STATICS  ELECTRICITY ACTION IS compulsory to be taken

    otherwise the LED maybe out of order before you use it!)