Pair - 2 rings supplied
 

• Adjustable elevation - compensation of +/- 30 MOA
• High - to accommodate larger objective scopes
• Double torx screws to hold your scope firmly in place
• With a removable recoil stop pin
• Reversible dove tail clamp that fits 9-11mm and 3/8 inch
• Internal cushion tape prevents marking and damage
• High grade aluminium anodized in matte black
• Height: 54mm / 2.1″
• Weight: 114g / 4oz

30mm Tube -

• Ring is 30mm diameter.
• To suit scopes with 30mm diameter tubes.

High Profile Height -

Overall Height 54mm

• 20mm base to bottom of ring "Saddle"
• Allows for outer objective case diameter size of 69mm
• See scope clearance guide at bottom of page.

Calculating scope to rifle body clearance

The way you calculate the clearance is by halving the overall OUTSIDE diameter of your scope objective lens and then deducting half the rifle scopes body tube diameter.

For scopes with a 1" diameter body tube diameter this would mean deducting 12.7mm and 15mm for scopes with a 30mm diameter body tube.

Note we say OUTSIDE diameter - this means NOT the lens diameter, you need to measure the whole outer casing diameter.

The result gives you the minimum "saddle" dimension required - the measure from base of mount to bottom of the ring.

The amount the saddle dimension is greater than the figure you have calculated is the amount of clearance your scopes objective will be clear of your rifles body.  The saddle on these mounts is 20mm

Example -

1. A 56mm objective lens scope is measured and found to have an outer case measurement of 66mm.
2. 66 divided by 2 = 33
3. 30mm scope so deduct 15mm = 18mm
4. So the mount must have a measure (bottom of mount to bottom of the ring) greater than 18mm or else it will ground out on the rifle body.
5. Here we have 2mm spare so it is a good fit