These are TRANSFORMERS AUTOBOT decals made from outdoor all-weather vinyl.
It is made from translucent material so it appears that it has been etched or sandblasted into the headlight or glass window.
You will get two (2) decals for one low price.
Approximately 3.75" tall X 3.75" wide in size. Sized perfectly to fit most headlights as shown in picture.
When headlights are on, it is highly visible, but does not restrict headlight beam.
You can install this on any smooth surface such as glass, mirrors, car windows, tail lights, headlights, etc.
Easy to install in minutes! No modifications
to vehicle needed.
How to install:
1. Clean vehicle surface thoroughly with soap and water or cleaner/degreaser,
then again with rubbing alcohol to remove all wax.
2. Measure to center
and align decal. Install decal when temperature is above 50 degrees. Only apply
decal to surface that is cool to touch. Not on hot surface or direct
sun.
3. Peel paper backing from decal very slowly ensuring the decal
sticks only to the top paper tape.
4. Very slowly and carefully apply
decal to vehicle surface. Do not get in a hurry and risk damaging your decal.
5. Before peeling off transfer tape, apply firm pressure to the decal
with item such as squeegee. (decal adhesion is pressure sensitive)
6. Very
slowly and carefully peel transfer tape, starting at one corner and pull at
right angle to prevent decal from lifting from vehicle surface.
7. Cover
decal with transfer tape and once again apply pressure from the center out if
there are any air bubbles. Any air bubbles can be removed with a needle/pin as a
last resort if they cannot be removed with firm pressure from a squeegee.