1983 Honda CR125R Clutch Cover W/ Gasket Set

Location:  NOS 24 / T

No Longer In Production - Last One!

Get your CR125R going again! No need to worry about a rotted out water pump cover ever again!

This is an aluminum clutch cover assembly. It is the highest quality clutch cover you can buy. Its made exactly the same way as the oem clutch cover, but its made from aluminum. 

This is not a cheap reproduction cover. 

This is the cover Honda should of made, and ended up making later. Rather than being made out of magnesium so it rots easy, this cover is made from aluminum. The only difference from the factory cover, is that the word "Honda" is not on the cover. Any machine shop would be able to cut that into the cover for you if you desire. 

Cover Replaces OEM Part Number:
11340-KA3-710

This cover comes with a complete gasket, bearing, and seal kit to properly install your new clutch & water pump cover. The parts in the kit are genuine Honda parts except for the gaskets which are still to spec and the same high quality material Honda uses.

Included in this Gasket Kit:

1 x Right Side Clutch Cover Gasket (Discontinued By Honda!)

2 x Clutch Cover Dowel Pin (8x14)

1 x Oil Filler Cap

1 x Oil Filler Cap O-Ring (11.9x2.2)

2 x Oil Check Bolt

2 x Oil Check Bolt Gasket

1 x Kickstart Shaft Oil Seal (16.5x25x25)

2 x Water Pump Cover Gaskets (Discontinued By Honda!)

2 x Water Pump Cover Dowel Pin (8x10)

1 x Water Pump Bearing (12x28x7)

1 x Water Pump Oil Seal (12x23x5)

1 x Water Pump Seal