CableClear Cable Manager For Wall Mounted TV

CableClear is an innovative new product to hide unsightly hanging cables from wall mounted TVs. With CableClear you can quickly and easily hide those ugly cables inside the stud wall of your home without any special DIY skills!

CableClear creates a 50mm conduit inside the wall cavity so that you can feed cables through and hide them completely. There is no excess damage to the wall during installation so there's no repairing or re-painting afterwards.

Key Features
• Quick and easy to install
• Hides cables up to 1m (3'4") inside the wall (Optional Extension kit available)
• Designed for all stud walls 70mm and thicker
• Fits plasterboard up to 13mm thick
• Creates a sealed duct so no insect or dust ingress into walls
• Cables are gravity fed through the CableClear easily
• AUS/NZ, USA and Euro plugs fit through the 50mm (2") hose
• Creates a sealed duct so no insect or dust ingress into the walls
• Components comply with UL 94 V-0 plastics flammability standards

Easy Installation

CableClear is quick and easy to install in a new or existing wall. It only takes a few minutes and you don't need any special DIY skills or extra tools; a hole saw, plumb bob and nose cone are all included.

There's no removing plasterboard and you won't need to repair or re-paint any walls.

Installation video:
https://www.youtube.com/watch?v=zqTENXtOPQY

Adjustable Height

CableClear standard kit can hide cables up to 1m (3'4") inside the wall, however the flexible hose is fully adjustable to suit almost any TV height.

A 1m Extension Kit is available to hide cables a total length of 2m (6'8") inside the wall for TVs mounted extra high.

Installation video:
https://www.youtube.com/watch?v=vSk0nfm0jdg

Engineered For Safety

All CableClear components are manufactured to the UL94 V0 flammability standard, so CableClear not only meets but exceeds the V1 standard set by most international building safety codes for in-wall electrical conduits.

Fits Standard Walls

CableClear is designed for new or existing standard stud walls including 70mm (2 ¾"), 90mm (3 ½") and thicker. The elbow and spring mechanism is designed for all plasterboard / drywall sheeting from 9mm (⅜") up to 13mm (½") thick.

Gravity Feed Cables

The 50mm (2") diameter hose allows most cables to be gravity fed through without needing any wire pulling rods. Standard Australian, USA and Euro wall plugs generally fit right through so there is no cutting cables and voiding your TV warranty.

Additional cables can be added anytime with no hassle. There's no need for a costly call back to add that one extra cable.

Insulation Is No Issue

If you encounter insulation in the walls during installation, the included specially designed CableClear nose cone and plumbob are designed to make it easy for you to install the hose.

1. Screw the CableClear insulation cone onto the trimmed hose, and tie the plumb bob string onto the insulation cone.
2. Feed the plum bob through the top hole down inside the wall cavity between the insulation and the plasterboard/drywall sheeting and pull the plum bob out through the bottom hole.
3. Feed the cone into the top hole and pull the string down firmly to pull the hose through the insulation until the elbow reaches the top hole.
4. Depress the elbow springs, rotate the elbow into the hole, guide and release the springs into the hole and then gently push the elbow into position.
5. Pull the hose out through the bottom hole, unscrew the insulation cone and screw on the hose connector.