Selling the header pipes one at a time. These header pipes were purchased from Dixie distributing when they went out of business. There was no part number found and I could not find them in any of the old catalogs I had for Dixie. I surmised the fitment from the following: the one and of the pipe that goes into the engine has a single flange with a hole just like a shovel head would have. There is a crossover flange about halfway down which leads me to believe that it is for a dresser model. The only thing I'm not sure of is what year this fits. The opposite end from where the pipe bolts to the head is one and three-quarter inch outside diameter. The inside diameter of the middle hole is one and three-quarter inch. Since I'm not 100% certain of the fitment please look at the pictures carefully and make sure your old pipe looks exactly the same. I took pictures with a tape measure so compare your measurements against mine. Please note that although these are new they been banging around the box for decades so they're not going to be in perfect condition and have scratches. There is going to be some surface rust also.
We purchase tractor-trailer loads of inventory from Dixie International and Dixie Distributing when they liquidated the business. Please keep in mind that this is older inventory that has been sitting in warehouses for decades.