How to operate :
1.Check the rhinestone design. On a hard side, press fingernails over the plastic to nudge offset stones back into position. If needed,trim with scissors.
2.Lay the shirt flat onto the desk,set your iron to a medium-high setting (wool or cotton), approximately 180-190 degrees. Turn the steam OFF.
3.Peel the white paper backing off the plastic transfer sheet. Place the transfer sticky side down on the shirt. It may be gently removed and re-positioned at this point to get it exactly where you want it.
4.Iron the transfer with firm, even pressure. Do not wiggle the iron. Press and hold the iron onto all areas of the transfer for about 18 seconds,
The time can depend on the size of the stones. Large stones take more time; metal studs take less time. Make sure that all stones are heated and have pressure applied.
The stones under the iron’s vent holes will not receive pressure, so re-position the iron once or twice.
Tips:Insert a piece of paper between the front and back of the shirt so the glue will not seep to the back side.
5. Gently and slowly peel the plastic away when the plastic cool to room temperature. The stones will remain on the fabric. If any stones are lifted up, replace the plastic and re-iron the areas where the stones were lifted.

Size is about :
#1:11 inchesx1.18 inches(28cmx3cm)
#2:11 inchesx1.6 inches(28cmx4cm)
#3:10 inchesx2 inches(25cmx5cm)
#4:11.8 inchesx2 inches(30cmx5cm)
#5:8.5 inchesx2 inches(21.7cmx5cm)
#6:10.2 inchesx6 inches(26cmx15cm)
#7:13.4 inchesx1.18 inches(34cmx3cm
#8:11.8 inchesx4.9 inches(30cmx12.4cm)

Colours:Silver stone

Warmly Tips and note:
If you don't have ironing experience, please try ironing on other similar fabrics with loose drills
These iron on rhinestone transfers are not intended for use by or near small children. Please do not allow children access to these products.