1 Set to power on

Enter the main menu "Advanced", enter "ACPI Settings", set "Restore on AC Power Loss" to "Power On".

2 Turn on K mode

"Mining Mode" in the main menu "Chipset", there are some different options for different models and different versions.

If there is "Enabled", then just choose this one.

For other values, select according to the motherboard model, for example, select "6X VGA" for a 6-card motherboard; if it is 8 or 12 cards, select "Above 6X VGA"

3 Set up MAX TOLUD

Enter the main menu "Chipset", enter "System Agent (SA) Congfigration", set "MAX TOLUD" to "3.5G"

4 Set the graphics interface speed

Enter the main menu "Chipset"

4.1 Enter "System Agent (SA) Congfigration" and set "Max Link Speed" to "GEN2".

4.2 Enter "PCH-IO Configration", then enter "PCI Eexpress Configration", all set to "GEN2".

5 Open CSM Support

A card needs to open this setting, N card does not need.

Main menu "Boot", set "CSM Support" to "Enabled".

After the setting is completed, you need to enter the main menu "Save & Exit", select "Save Changes and Reset", save the settings and restart.

Reset the motherboard

If you find that the motherboard is working abnormally, you may need to reset the motherboard.

Turn off the power first. Find the "JCMOS1" two pins on the motherboard and short-circuit them for about 5 seconds to complete the reset. After resetting, you need to reset the parameters of the motherboard. Since WIN7 system has restrictions on A card and N card drivers, we recommend using WIN10 64 system in order to reduce unnecessary problems. We recommend using WIN10 1703 64-bit system. (It must be the original installation version of 1703 system. It is strictly forbidden to use other versions or public package image packages, GHOST system, which will cause K instability, incomplete recognition, loss of computing power in K and other serious problems)