Replacement Hobart mixer part, Switch plate and timer assembly for Hobart mixers Model's H600T L800T P660. This is 100% to Hobart specs. Comes with 15 minute 230 volt timer, 115 vac timer version is available on request, On and Off switches with rubber boots to seal out moisture and food product. Also has the back plate gasket seal, mounting screws, new insulated flag terminals for switches and correct flag terminals for the timer. Mylar insulator between timer and switches. Comes assembled as shown. This assembly is a small fraction of the cost from Hobart. Should there ever be an issue with this assembly many years down the road every part on it can be purchased over 100 Hobart offices nationwide or Hobart's website. This part from Hobart is over $546.00, Plate part number is 00-291729
NOTE: You must have a push button control on your mixer now for this to work. It will not replace the slide knob early models without more modification to your motor electrical controls.
Features:
- 100% to factory specs
- All markings etched down into the Brushed aluminum on/off plate and shifter plate. Un-etched markings cannot survive the many cleanings of the mighty Green Scotch-Brite cleaning pad found in most commercial kitchens today as it is basically flexible sandpaper, A mixer with no makings is an unsafe mixer!
- 230 volt 60HZ spec timer with new set of correct flag terminals UL listed
- Factory style switches. UL listed.
- Rubber switch covers and back sealing gasket to seal out moisture and food products for safety and sanitary issues.
- New insulated flag terminals for switch's.
- All parts for this can be ordered from Hobart's over 100 offices or their website online.
- This plate is 100% serviceable by Hobart technicians should there ever be a issue down the road.
- S/S mounting screws for both plates.