Casting Over Furnace electrical muffle kiln 950
Description
220VAC version with EU/RUSSIA standard plug (two round pins + E).
240VAC version with UK/IRELAND standard plug (three square pins).
240VAC version with a standard AU/NZ plug adapter (three flat pins)
- Power - 850 Watt;
- Power cable - 2 Meter;
- Secure switch to disconnect power supply when door is open;
- P.I.D. digital controller will reach and hold a required temperature as long as you need until you will change the temperature manually or switch this kiln off.
- Internal chamber dimensions in mm
(Inch) - 175 (7")W x 175 (7")H x 140 (5.1/2")D;
- Kiln's dimensions in mm (inch) - 240 (10")W x320 (13")H x 250 (10")D;
- Maximum heating temperature - 950 C (1772 F);
- 16 mm ventilation hole with a shutter on the door x 2;
- Estimated heating time (to 950 C/ 1772 F) - 50 minutes;
- Easy-to-use latch toggle clamp handle with a stainless steel ring;
- 25 A solid state relay;
- one year manufacturer warranty
- Instruction manuals on the kiln and a temperature controller - email
The mechanical damage to the chamber and/or heating element is not covered by warranty.
Before placing the order please make sure that the internal chamber dimensions mentioned in the description suit your needs. This is to avoid unnecessary expenditures due to return postage.
Internal chamber dimensions should allow you to fit both shelves and items inside in such a way that there is no chance they would touch the heating elements.
To keep & care your machine for a long time
Place your work on a fire resistance plate inside
The oven to catch any resin build up like in pictures,
If you note that there is a heavy smoke then few things you can do: leave door slightly open. There is a safety switch to u/s therefore if door is open it wont allow current in and the kiln wont run, however leaving it slightly open (not locking it) will create extra ventilation.
the other measure is after you are done with your work leave the kiln on for 30 minutes. this would allow complete burn out from the element and wont make wax or other material to build on the element
the temperature in this case is not as important as smoke and settlement of melting material on the element and creating electrical conductivity between the rows keep your work away from the back wires inside the kiln. If you are melting wax then we strongly recommend a fire resistance plate to catch any excess this fire stone is not included and you will have to pay extra if needed
The best way to have a successful Burnout set the machine to 300 then 600 and higher if needed, leave door slightly open till no smoke is visible once there no Burnout material markings on the bottom plate means you have a full Burnout and then door can be closed to get floss to desire temperature.
Returned accepted
14 days policy
we don't accept return on item that is Used and not in the original state we send it.
Delivery 7 ~ 12 days