40inch Car LED Rear 3rd Stop Brake Strip Light Signal Lamp Driving Warning Turn
Specification:
1.Voltage: DC12V
2.Light Source:LED
3.Color: red
4.Length: approx 100cm/39.37inch
5.Fitment: For all most Cars
6.Waterproof: Yes,IP67
7.Functions: Brake + DRL Drive light+ Turn Signal + Double Flash
8. LED Type: Specification:
1.Voltage: DC12V
2.Light Source:LED
3.Color: red
4.Length: approx 100cm/39.37inch
5.Fitment: For all most Cars
6.Waterproof: Yes,IP67
7.Functions: Brake + DRL Drive light+ Turn Signal + Double Flash
8. LED Type: 2835 LED
9. LED qty: 144Pcs SMD
With Flash, Flow Modes
4 Functions:
Running mode, all LED light up (low beam)
Brake mode, all LED light up (high beam)
Turn mode, flow sequential LED light up
Double flash mode, LED light up and spread from the center to the sides
Note:
Please also measure your rear window size before buy this product. This item is approx 100cm/39.37inch.
Features:
100% Brand New and high quality
No special too, no drilling or screws required.
Easy To Install,double side adhesive tape available for installation
Super bright LED, energy saving, long life,over 50000 working hours
High temperature resistant, more security and stability
LED lights less heat radiation, low power consumption, long service life
How to Install:
1.Please use detergent or alcohol to clean the surface of the target area before stick it on.
2.Use the hair dryer to heat the tape a little.
3.Stick it on and keep your car non-washed. within 48 hours to achieve the best adhesiveness.
4.Try to finish the steps one time,do not peel off from one area and stick on another area to avoid bad adhesiveness.
Package included:
One Rear Windshield LED Third High Brake Light Tail Lamp
9. LED qty: 144Pcs SMD
With Flash, Flow Modes
4 Functions:
Running mode, all LED light up (low beam)
Brake mode, all LED light up (high beam)
Turn mode, flow sequential LED light up
Double flash mode, LED light up and spread from the center to the sides
Note:
Please also measure your rear window size before buy this product. This item is approx 100cm/39.37inch.
Features:
100% Brand New and high quality
No special too, no drilling or screws required.
Easy To Install,double side adhesive tape available for installation
Super bright LED, energy saving, long life,over 50000 working hours
High temperature resistant, more security and stability
LED lights less heat radiation, low power consumption, long service life
How to Install:
1.Please use detergent or alcohol to clean the surface of the target area before stick it on.
2.Use the hair dryer to heat the tape a little.
3.Stick it on and keep your car non-washed. within 48 hours to achieve the best adhesiveness.
4.Try to finish the steps one time,do not peel off from one area and stick on another area to avoid bad adhesiveness.
Package included:
One Rear Windshield LED Third High Brake Light Tail Lamp