6mm DIN Immersion Liquid Viscosity DIN Cup Aluminum DIN Flow Cup for Print Ink
Introduction:
- Use a suitable solvent to wipe clean before and after use.
- Immerse the cup body in the container for 1~5 minutes to make the cup body reach thermal equilibrium, lift the cup body vertically from the raw material, and move fast and smoothly.
- The timing starts from the upper end of the cup body leaving the liquid surface. Keep the cup vertical when the liquid flows out, and the distance from the liquid surface should not exceed 150mm.
- Stop timing when the first breakpoint occurs, and the difference between the two measured values should be less than 5% of the average.
- The portable DIN cup is manufactured in accordance with the standard of DIN 53211 "The DIN Cup for Inspection of Paint, Paint and Similar Coating Materials Determines the Flow Time".
Application:
- Used to determine the viscosity of inks, coatings, paints.It is opened by the bottom orifice, the refining capacity of 100ml of high-quality aluminum cup. Ford cup is to evaluate the viscosity of the material by measuring the time required by the flowing out of the hole in the bottom of a certain volume of the sample of the aluminum cup.
Parameters:
- Model No. : 6#
- Cup material: Aluminum
- Capacity: 100ml.
- Cup inner diameter: Φ6±0.02mm
- Cup body width 55 mm, cup height 73 mm, total length 270 mm
- Ideal measuring range: 300 ~ 1500 cSt
- End of flow time (s): 20-110
On May 23, 2022 at 02:03:50 PDT, seller added the following information: