(Product introduction)
Ultrasonic cutter ZO -80 II for echotech hobby.
・Best cutting S-High mode for hobby ultrasonic cutter
(S-High mode is not a function to be used all the time.)
・Power switching in three levels (Normal mode, high mode, super high mode)
・The optional ZH 801 footswitch turns off the timer for 10 minutes.
・Handpiece part only can be purchased additionally (ZH 802/ZH 803)
・Auto-stop function (Normal mode 10 minutes, High mode 5 minutes, Super High mode 3 minutes)
(Accessories)
・Replacement blade (BDC 200 P): 1 case (40 sheets) * Blades with holes can not be used.
・Blade Fixture ZH04: 1
・Blade fixing screws HB03: 3
・Hex Wrench RR02: 1
・AC adapter: 1
■Regarding the replacement blade of ZO -80 II
Normal mode and high mode are the same as the ZO -41 and ZO -41 II.
*Polishing wheel rods ZH 55 to ZH 63 are not compatible.
Super High Mode can only drive standard blade and long blade 25 mm ZH 10.
*Some replacement blades require a dedicated blade fixture.
(Product specifications)
Oscillation frequency: 40 kHz
Power consumption: Up to 110 VA
power: AC adapter
・INPUT: AC 100 -240 V 50/60 Hz
・OUTPUT: 12 VDC
Dimensions: Oscillator (body) 185 x 169 x 55 mm
Handpiece: phi 28 x 150 mm (blade included), Handpiece Cable: 1.6 m (straight)
Operating temperature range: 10 ~ 35 degrees Celsius (However, it should not condense)
Mass: Oscillator (body) approx. 1.2 kg, Handpiece: approx. 350 g (including Handpiece Cable)