The load is relatively small and the motor does not work continuously for a long time, the governor shall not be less than 50% of the full speed
The load is relatively large and the motor works continuously for a long time, the governor shall not be less than 70% of the full speed
1, Gear detector (all-round inspection of gears)
2, Vickers hardness tester, Rockwell hardness tester (test hardness again to ensure wear resistance)
3, Radial runout detection (detecting motor running-in, balance to reduce motor wear, no noise when running at high speed)
4, Withstand voltage tester (to detect leakage, higher than normal voltage, no leakage)
5, inter-turn tester, surge test motor stator winding insulation between turns, thick coil, same power torque output, larger torque
6, Stator comprehensive tester: Check for defects after the motor stator is embedded, and investigate and deal with unqualified defective producs (stator: the part of the motor that is fixed on the casing corresponding to the rotating part)
7, Motor comprehensive tester: test the data of the motor to meet the standard
8, Dynamometer: Welding, insulation, power frequency withstand voltage, turn-to-turn withstand voltage against any chip, any impact method and repeated impact times. Can automatically and correspond to multiple waveforms to judge other inter-turn withstand voltage tests
9, Before the motor is shipped, power-on inspection and debugging