eBay

Fitment:

For Kawasaki ER-6F 2012-2017

For Kawasaki ER-6N 2012-2017

For Kawasaki KLE650 2010-2017

For Kawasaki Ninja 250R(Fi model) 2013-2015

For Kawasaki Ninja 300 2013-2018

For Kawasaki Ninja 400R 2013-2016

For Kawasaki Ninja 400 2018

For Kawasaki Ninja 650 2012-2016

For Kawasaki Ninja 1000 2011-2016

For Kawasaki Versys 650 2010-2018

For Kawasaki Versys 1000 2012-2018

For Kawasaki VN900 2011-2015

For Kawasaki Vulcan S 650 2015-2018

For Kawasaki Vulcan 900 2011-2018

For Kawasaki W800 2011-2017

For Kawasaki Z300 2015-2016

For Kawasaki Z650 2017-2018

For Kawasaki Z750 2010-2012

For Kawasaki Z750R 2011-2012

For Kawasaki Z800 2013-2017

For Kawasaki Z800e 2013-2017

For Kawasaki Z1000 2010-2016

For Kawasaki Z1000SX 2011-2016

For Kawasaki ZX-6R 636 2006

For Kawasaki ZRX1200 2011-2015

For Kawasaki Brute Force 750(ATV) All Years

For Kawasaki Mule (ATV) All Years

For Kawasaki Teryx (ATV) All Years

(If you encounter any questions, please be sure to contact me first, please do not leave negative comments first, I very much hope to answer your questions, thank you)

Description:

-Condition:100% Brand New

-Item Name:Speed Gear Display Indicator

-Green light
Feature:

Shows current gear number

Indicates current gear from 1 to max of 6. as well as a neutral indicator.

Detects the current gear faster than other gear indicators that use speedometer/tachometer signal.

Display can be mounted anywhere

Installation:

Find the 4-pole male diagnostic connector(DLC), usually near the ECU box,It may have a removable cap and may be partially covered by black tape.

Set up:

-You need to setup the module after installation. When ignition is turned on, the display counts backwards (6 to 1) indicating that the memory is clear.

-Raise the rear wheel off the ground by using a stand, and start the engine in Neutral. (If you do not have a stand, you may setup the unit while riding. Find a long, straight road with light traffic.)

the screen displays L, indicating that learning is started.

accelerate through the handle throttle slowly

-The display will blink “1”.Select first gear, release the clutch, and keep the RPM above idle speed. The display is blinking faster while the unit is learning the gear.

-When the display shows “2”, select second gear.

Repeat this process until all gears are thought (5 or 6).

The unit is programmed and should indicate the gears correctly.

Now, when ignition is turned on, the display counts forward (1 to 6) indicating that it is fully functional.

(If there is an error in the learning process, please reset gear indicator, thank you)

Reset:

If some gears are not indicated correctly, please reset gear indicator.turn on the key switch of the switch lock. When the gear indicator shows 5.4.3, turn off the key switch of the switch lock immediately, and then turn on the key switch of the switch lock immediately. According to the above operation, turn on and turn off the key switch of the switch lock five times in a row to see if the reset is complete. Thank you