For Kawasaki ZX-6R (2003-2008)
For Kawasaki ZX-6RR (2003-2006)
For Kawasaki ZX-10R (2004-2007)
For Kawasaki Z750 (2004-2006)
For Kawasaki Z1000 (2003-2006)
For Kawasaki ER-6N (2006-2011)
For Kawasaki ER-4N(2010-2014)
For Kawasaki ER-4F(2010-2012)
For Kawasaki ER-6F (2006-2011)
For Kawasaki Ninja 250R [FI only, not in USA] (2008-2012)
For Kawasaki Ninja 400R 2010-2012
For Kawasaki Ninja 650R (2006-2011)
For Kawasaki KLE650 (2006-2009)
For Kawasaki Versys650 (2006-2009)
For Kawasaki ZRX1200 DAEG(2009-2010)
For Kawasaki Vulcan 900 (2006-2010)
For Kawasaki VN900 (2006-2010)
For Kawasaki Vulcan 1700 (2009-2010)
For Kawasaki VN1700 (2009-2010)
For Kawasaki KFX450R [ATV] (2008-2010)
For Kawasaki Vulcan 2000 (2004-2010)
For Kawasaki VN2000 (2004-2010)
For Kawasaki KVF 750 [ATV] (2008-2010)
Set up:
-You need to setup the module after installation. When ignition is turned on, the display counts backwards (6 to 1) indicating that the memory is clear.
-Raise the rear wheel off the ground by using a stand, and start the engine in Neutral. (If you do not have a stand, you may setup the unit while riding. Find a long, straight road with light traffic.)
the screen displays L, indicating that learning is started.
accelerate through the handle throttle slowly
-The display will blink “1”.Select first gear, release the clutch, and keep the RPM above idle speed. The display is blinking faster while the unit is learning the gear.
-When the display shows “2”, select second gear.
Repeat this process until all gears are thought (5 or 6).
The unit is programmed and should indicate the gears correctly.
Now, when ignition is turned on, the display counts forward (1 to 6) indicating that it is fully functional.
(If there is an error in the learning process, please reset gear indicator, thank you)