The 3D PrinterTouch auto leveling sensor is a device that uses the Hall defect to achieve leveling .The position of the point can be obtained by touching the point on the heated bed ,and then compensated by adjusting the Z-AXIS height during printing ,Printing can also be achieved even though the platform is not flat .
Features simple, smart and precise. It could work with nearly any kind of bed materials, such as glasses, woods, metals and so on. The position of the point can be obtained by touching the point on the heated bed, and then compensated by adjusting the z-axis height during printing.
The main functions and controls of 3D printer touch are the same as most auto bed leveling sensors, which consists of a RC servo and a micro switch,thus,3D printer touch can be used on almost every 3D printer control board.
NOTE:
Pulling/pushing hardly on the push-pin may damage Touch sensor and make it less accurate. Any problem when you receive the order, CONTACT US FIRST please!
By using progressively designed solenoid and hall sensor, it can integrate high precision in such a simple structure.To make it more user-friendly and to bring you more enjoyable
printing experience.
Product parameters:
Voltage 5V
Current 15ma
Maximum (peak) current 300mA
Shell material PC
Shell color white translucent
Line length Short line: 200mm Long line: 1000mm
3pin: green (-, GND)
Red (+5V)
Orange (signal line)
2pin: black (-, GND)
White: (Zmin)
3D Touch Packing List:
1pc Sensor
1pc 200mm cable
1pc 1000mm cable
1 set terninal
2pcs M3 Screw Nuts
1pc XH2.54mm 2 Pin terminal
1pc XH2.54mm 3 Pin terminal