A replacement front wheel hub bearing assembly for either side.

Complete with fitted ABS sensor and replacement driveshaft nut.

It is essential that replacement wheel bearings are fitted correctly and tightened to the correct torque. Please refer to the workshop manual for the proper fitting procedure. Incorrect fitting will cause premature bearing failure and ABS system faults and will void the warranty.

PLACEMENT: Front, left, right

EQUIVALENT TO LAND ROVER PART NUMBER(S): TAY100060

SUITABLE FOR THE FOLLOWING LAND ROVER MODELS:

Discovery 2, 1998-2004, All models, Front, left, right

IMPORTANT INFORMATION

Please read before commencing the fitment of this wheel-bearing hub assembly.

-After removing the old unit and fitting the new hub onto the vehicle, ensure the driveshaft hub nut has been torqued to 490Nm.

-Then clear the fault codes already stored in the system.

If this is not done, your ABS light may not cancel, and the bearing may fail prematurely and will not be covered by warranty.