Rotary Table 3" ( 80 MM ):-

• Chuck Diameter 3″ (80 mm)

• -Table Height: 1 5/8"

• -Base Dimensions: 4. 1/8" x 3. 1/4"

• -Center Height in Vertical Position: 1. 11/16"

• -T-Slots: 5/16"   

• -Operates in the Horizontal or Vertical position

• Hand Wheel can be set to zero

• Hand Wheel graduated in 10 min divisions

• Cali berated in 5 min increment around the rim

• 36 : 1 ratio

• Can be used both Horizontally & Vertically.

• Milling curved profiles and angled faces relative to a centre line.
• Drilling or milling to polar co-ordinates and, when mounted vertically with a tailstock they can be used to machine shafts or spindles. The versatile units can also be used on drilling, boring or slotting machines permitting an even greater range of operations. 
• -Machining - To establish the initial work piece position simply loosen the zero Collar locking handle and rotate the zero collar anti-clockwise for about half A turn. The worm is now disconnected from the worm wheel drive, the table is Free to turn independently to the crank handle and the work piece may now be Accurately aligned. To re-engage simply turn the zero collar in the clockwise Direction and re-tighten the locking handle.

• To machine spanner flats on a bolt
• To drill equidistant holes on a circular flange.
• To cut a round piece with a protruding tang
• To create large-diameter holes, via milling in a circular tool path, on small milling machines that don't have the power to drive large twist drills (>0.500"/>13 mm)
• To mill helices
• To cut complex curves (with proper setup)
• To cut straight lines at any angel.