【Open Gear Style】Open gear bass tuning pegs fit for electric bass, like jazz bass and precision bass;

【Premium Material】Use high-grade alloy handle and steel gear, which are smooth and wear-resistant, anti-corrosion, to meet your requirement of accurate tuning;

【Full Set Accessories】Package Includes 4 Bass Tuning Pegs, 4 x ferrules,16 x screws;

【Easy Installation】Please See the installation instructions below;

【Delicate】Exquisite appearance with perfect workmanship.

Descriptions:

Please check the parameter diagram in the attached picture before you place your order.

Specifications:

◇Color：Chrome 

◇Material: high-grade alloy handle+A3 steel plate+ iron string+steel gear

◇Handle width: 1.57’’

Package Included:

4 x Bass Tuning Pegs

4 x Ferrules

16 x Screws

Installation Tips:

1.Please check the bushing against the hole first, slightly ream the holes out then test the fit. Do not slam it in. Just use the very tip of the bushing to slip in.

2.Then you can take a bolt with 2 flat washers and a nut and then use that to install by simply tightening it all up and this will press the bushing in with even pressure all the way around.

3.You can use some tape on the bushing and on the back of the head stock so you don't damage the wood. Once the bushing is seated then loosen the nut and remove the bolt from the hole and do this. Set one at the tuners in and make sure this is lined up as if it were already installed and mark your four screw holes. Do this for each tuner .

4.Then, to drill pilot holes for each of the four screws and do that for all the screw holes on each tuner. Put the tuners on and screw them to the head stock. Please remember to remove the tape before you did all this.