Please Read this information.. Its important because we do not want you to order these keys if you 
are going to be unable to use them.  Thanks for READING  MY  COPY.. any questions just ask..

DO NOT ORDER THESE KEYS UNLESS YOU ARE CERTAIN THAT YOUR PINS HAVE BEEN REMOVED FROM YOUR

DOOR LOCK. If your not sure ask a Locksmith to check your lock to see if the Pins have been REMOVED…

Please Look At my last photo of a lock face that shows small half circle holes in the area around the stem of the lock 

face.  IF ON YOUR LOCK FACE YOU CAN SEE THAT THERE IS BRASS OR SILVER COLORED PINS IN THE 

HALF CIRCLE HOLES YOU STILL HAVE PINS IN YOUR LOCK.  And these keys are only good only if your pins 

have been removed.

Pachislo Slot Machine Door Keys You will receive  4 pc.

THIS KEY is for locks having 5-6 mm STEM ..ONLY…..

STEM : Is the center of the door lock in the middle that the key goes over when pushing the key into the Lock.


Please read all info :  

THESE ARE BLANK UNCUT KEYS ONLY TO BE USED FOR PACHISLO SLOT MACHINES

THAT HAVE THE PINS REMOVED FROM LOCK. IF YOUR NOT SURE IF YOUR PINS HAVE BEEN REMOVED PLEASE

SHOW  YOUR  LOCK  TO  A  LOCKSMITH..

Please look at my photos of the type of lock theses keys fit .

Notice some Locks have a wider stem in the center of lock and some have a smaller stem in the center of lock..


These Keys are for the smaller stem in center of lock.

And Remember your Pins must be removed for these keys to work.

Pins can be removed by a Locksmith or an experienced mechanic who understands how the lock comes apart.

IMPORTANT  NOTE :   IN  SOME  CASES  YOU  MAY  NEED  TO  GRIND  OF  THE  SMALL  TOOTH  ON  THE  OUTSIDE  OF  KEY  IF IT  IS  IN  THE  WAY  WHEN  SLIDING  THE  KEY  INTO  LOCK...

KEYS MUST NOT BE FORCED when opening the door because they can break. 

 THESE keys are Casted and that’s the only way they were able to be made .

And if they break and you are unable to turn the lock this may be because your pins are still in your lock.

IMPORTANT INFO PLEASE READ

IF THE KEY OPENS THE DOOR ,, BUT it is hard to turn look at the spring on the inside of door latch assembly.

Take out some of the spring tension so it becomes easier to

TURN THE KEY.

YOU CAN DO THIS BY STRETCHING THE SPRING A LITTLE.

If the tension that the spring provides is TOO  much the key will

always be to hard to turn and YOU  WILL  BREAK   KEYS.

I hope you understand.


We give 4 Keys to Customers in case they break one or two.

Please remember if a key breaks your door spring is to tight or

the door mechanism is not sliding easy enough and can be adjusted by stretching the spring .

Or try a little lubrication on sliding door mechanism.

Most all machines have a spring on the inside door sliding mechanism.

A lock should not be hard to turn if a key does open door.