Description
12 x Caulk Mate Decorators Caulk
Easy to apply, quick drying - smoothed and painted within 1-2 hours!
A quick drying, interior, acrylic decorators filler for gaps and cracks that can be smoothed and painted within 1-2 hours of application. Bonds with most surfaces.
Good adhesion properties and can be used to seal door and window frames, as well as interior sealing of skirting boards and polystyrene coving. Bond-It Caulk-mate is also suitable for sealing interior partition joints around fitted furniture and repairing small cracks and joints with no movement in plaster or wood. A quick drying interior decorators filler that can be smoothed and painted within 1-2 hours of application. Sticks to most surfaces including wood, light fittings, stair risings, plaster, brick, concrete, and plasterboard.
Why buy Bond-It decorators caulk?
Quick drying - (tools in 5 & skins after 20mins) | |
Can be painted - after just an hour | |
Easy smoothing - just wet finger or spatula | |
Fills gaps & cracks - none sag | |
Easy Clean - just a rag & water | |
Multipurpose filler - good all round filler |
Ways to stop silicone joints failing
- Use a good quality silicone
- Choose the correct silicone for the job
- Clean all surfaces of dirt & grease
- Practice your gunning technique
- Ensure the joint width & depth aren't too large
Fitting and Usage
Preparation
All surfaces must be clean, dry, sound and free from dust, oil or any other contaminants that may hinder adhesion. If necessary, in addition to mechanical means, cleaning with a solvent such as acetone is recommended for degreasing.
Application
Apply using a standard sealant gun (skeleton gun). Cut the tip away from the cartridge, being careful not to damage the screw thread (silicone snips to make this easier). Cut the nozzle at an angle of 45° to an opening slightly larger than the gap to be sealed, and fix the cartridge. Smooth down within 5 minutes using a slightly wetted spatula or sponge. Do not tool down after the skin has started to form (within 15-20 minutes). Do not saturate the surface with water as this will delay the curing process. CAULK-MATE can be over-painted with emulsion paint as soon as a skin forms, approximately after 1 hour. For oil based paints, allow to dry completely for 24-48 hours before over painting. Remove excess product with a damp cloth.
Limitations
Not suitable when:- Applied at temperatures below +5°C
- Used in joints constantly immersed in water
- Used in contact with bituminous products
- Used in areas of high abrasion, e.g. floor joints
- Joints that are subject to movement
- Shelf life - minimum 12 months unopened