Working Voltage : DC 6V/12V/24V
Modulation Mode:ASK
Matching Mode: Intelligent Learning Code 1527.
Quiescent Current:5mA
Maximum load power: 300W
RF Frequency: 433MHz
Wiring method: NC COM NO
Circuit Board Size: 26 * 47 * 18mm
Output: single-channel passive switch quantity output
Max Relay Contact Current : DC 20A/AC 5A
Momentary: Press the remote button , the relay connects, release the remote button , the relay dis-connects.
Toggle: Press once the remote button, the relay connects , press twice the remote button , the relay dis-connects .
Latching: Press the remote button ON, the relay connects, press the remote button OFF, the relay dis-connect.
Delay Mode: Press the remote button , the output terminal of the receiver will be powered on for a certain time (5s/10s/15s/20s), and the output terminal of the receiver will be powered off.
Reset:Factory reset, this will erase all paired remotes!
Please note:We recommend using the Latching Mode, which uses one button for ON and one button for OFF. If you want to change to another mode, please follow the instructions on the product page to reset the product and select the working mode pairing.
1.Reset : Press the learning button on the module 8 times continuously, and the light flashes seven times and then goes out.
2.Momentary Mode:Press Module learning button 1 time, the indicator light is always on, then press the remote control button, the indicator light flashes 3 times and then turns off , then the learning is successful; If the code is not successful , the indicator lights out of the learning state after 15 seconds .
3.Toggle Mode:Press the Module Learning button 2 times, the indicator light always turns on; then press the remote control button, the indicator lights flicker three times and then off, then the learning is successful; if the code has not been successful, the indicator lamp goes out of the study state after 15 seconds.
4.Latched Mode :Press the receiver button 3 times, the receiver indicator light is always on, the receiver enters the code matching state, and then press the remote control button, the receiver indicator light flashes and then stays on, then press another button on the remote control, after the code is successful, the indicator light goes out.
5.Delay Mode : Press a certain number of times (4 times correspond to 5s/ 5 times correspond to 10s/ 6 times correspond to 15s/ 7 times correspond to 20s) to press the receiver button, the receiver indicator light is always on, the receiver enters the code matching state, then press the key of the remote controller, and the indicator light will go out after the code matching is successful.
Please note:We recommend using the Latched Mode, which uses one button for ON and one button for OFF. If you want to change to another mode, please follow the instructions on the product page to reset the product and select the working mode pairing.