The TB6600 upgrade driver is a professional two-phase hybrid stepper motor driver that can be adapted to domestic and international
brands, 4.0A and below, 39, 42 and 57mm outside diameters, four, six and eight wire two-phase hybrid
stepper motors. Suitable for all kinds of small and medium-sized automation equipment and instruments, such as: engraving machines, marking machines, cutting machines
laser marking, plotters, CNC machines, pick-and-place devices, etc. The stepper motor is suitable for a wide range of small and medium-sized automation equipment and instruments, such as engraving machines, marking machines, cutting machines, laser marking, plotters
The result is good in equipment where users expect low cost, high current operation.
Features
Signal input: single-ended, pulse/direction
Subdivision options: 1/2/4/8/16/32 subdivision
Output current: 0.5A-4.0A
Input voltage: 9-42VDC
* Current is automatically halved at standstill
4,6,8-wire two-phase and four-phase stepper motors can be driven
* Optocoupler isolated signal input, strong anti-interference capability
Overheat, overcurrent, undervoltage lockout, input voltage protection against reverse connection, etc.
* Compact size, easy to install
External signal 3.3-24V universal, no series resistor required

* Current is selected by dip switch * High-speed optocoupler isolation for interface * Eight adjustable subdivision

Automatic half-current to reduce heat generation ※Large heat sink for high temperature environment ※Strong anti-high frequency interference capability

*Inverting input voltage protection *Overheating and overcurrent short circuit protection *Red warning light for fault

Control signal connection.

PUL+: Pulse signal input positive. PUL-: Pulse signal input negative.

DIR+: Motor positive and reverse control positive. DIR-: Motor positive and reverse control negative.

ENA+: Motor offline control positive (not normally connected). ENA-: Motor offline control negative (not normally connected).

Motor winding connection

A+: Connect motor winding phase A+.      A-: Connects motor winding A- phase.

B+: Connection to motor winding B+ phase.      B-: Connection to motor winding B-phase.

Supply voltage connection.

VCC: power supply positive "+" GND: power supply negative "-"

Note: DC DC range: recommended 9-42V. up to 50V, do not exceed this range, otherwise it will not work properly or even damage the drive.