Specification:

Parameters

Lifter model: FSP15M5-single steel wire

Body material: Alloy SPCC

Lifter body size: 160mm*240mm

Lifter weight: about 2KG

Lifter adaptable height: <15M

Lifting speed: 3M/Min

Remote control distance: <100M

Installation Precautions

1. The lighting circuit must be connected in strict accordance with (L red line/N blue line).

2. The hanging objects should not touch the ground (at least 1 meter away from the ground).

3. The lifting operation is not empty (at least 1.5 kg of weight can be hung before lifting)

4. Do not exceed the ceiling limit, that is, do not exhaust the wire rope!

5. During the transportation process, do not pull the wires, and do not use hooks as grippers/pulling the wires. To ensure after-sales service, users are not allowed to disassemble the product without authorization.

6. Users must strictly follow the lifting requirements. This product uses a 20*15 synchronous motor. (Use for 20 minutes, stop for 15 minutes and then start again)

7. After the installation is completed, while the scaffolding is not dismantled, lift it up and down at least once!

installation method:

1. Prepare one M10 expansion ring screw before installation.

2. Make sure the ceiling mounting point can bear the total weight of the lift and light fixture

3. Drill holes in the ceiling, install and fix the M10 expansion screws on the ceiling, and confirm that they are installed securely. 4. Correctly install the lifter on the M10 expansion ring screws on the ceiling.

5. The lamp can be connected to the lifter on the ground, or the lifter can be installed first and then connected to the lamp during the installation process. The connection methods between lifters and lamps are generally screw connection, flange connection, and hook connection.

6. Connect the lifter and lamp power cord. The power cord is 0.75-1.5 square meters.

7. After use, make sure to press the stop button (ON/OFF) on the remote control switch.

8. Check the scaffolding frequently before dismantling it and run the lift several times.

Correct operating steps for lifting (no load allowed)

1. Correct operation: In the early stage of installing the suspension lift, you must hang the lamp on the ceiling and then start the lifting. Wrong operation: Do not hang heavy objects to lift after installation, or land on the hanging lamp without load. This is the wrong operation method.

2. Correct operation: later replacement of lamps, lowering the lift after removing the lamp, you must also hang other heavy objects up. Incorrect operation: lowering the lamp to replace the lamp, removing the lamp without hanging heavy objects, and directly pressing the up button is a wrong reminder: if during use Because there is no hanging weight or the object is too light, the wire rope is stuck and the remote control does not respond. Please stop pressing the remote control immediately.

Instructions for using a lift to repair lamps:

1. When the remote control lift is lowered to 1 meter above the ground, press the pause button. Do not lower the lamp to the ground when replacing the lamp, otherwise it will cause internal damage and cannot be lifted;

2. When debugging the lift, please do not stand under the lift.

Package Included:

1 x Chandelier Lifter

1 x Remote Control