Before welding
- Check the front & back polycarbonate lenses are securely in place to protect against impact, spatter, and scratching
- Adjust headband so that the helmet is seated on the head as low as possible and near to your face. Adjust helmet angle when in the lowered position by turning headgear
- Ensure helmet shell/frame does not obstruct solar panels or sensors, doing this may cause eye injury while welding
- Check the correct operation of the filter
Additional Instructions
Do not use or open the auto-darkening filter if damaged by shock, vibration or pressure. Keep the sensors and solar cell
clean. Clean the filter cartridge using a soapy water solution and soft cloth which should be damp but not saturated. Do
not leave lowered in position; a bright light surface could cause the filter to darken unexpectedly. Do not use solvents or
abrasive cleaning detergent. If cover lens is spattered or covered with dirt, it should be replaced immediately. Do not
use the helmet without inside and outside cover lenses properly installed.
Contact Us:
Discount Welds LLC
2745 NW 21st St, Miami,
Florida 33142, United States