Feature:

- Detects SF-6 in high voltage circuit breakers.

- Detects cleaning agents used in dry cleaning applications.

- Detects leaks in other systems and storage/recovery containers.

- Detects Ethylene Oxide gas leaks in hospital sterilizing equipment.

- Detects halogen gas and most gases which contain chlorine, fluorine and bromine.

- Detects all kinds of halogenated refrigerants including but not limited to CFCs, HCFCs, and HFCs.

- With precise ultra-low power consumption IC design, can be automatically adjusted to the best optimum detecting state.

Operation Instruction:

- Install 4 x AAA battery(not included)

- Turn the knob clockwise to turn on the leak detector, after 6 seconds, it turns into stand-by mode and begins to beep regularly. Then you can start detecting the leak.

- The detector will beep regularly at a slow frequency when turn it on. If leak detected, it will beep in a higher frequency. (2 beeps per second when the detector is open, 10 beeps per second when detect the leak）

- The sensitivity increases from 1 to 7 in sequence

- This Freon leak detector is designed with corona sensor so the probe should be very close to the gas leak area.

- Widely applied on pipe leakage, automobile air conditioner, cold storage, refrigerator repair and so on.

Specification:

Reset the time: 2-10 seconds

Working temperature: 0 °C ~ 52 °C.

Maximum sensitivity: 6gr/yr(halogen refrigerants).

Battery life: about 50 hours under normal use.

Response time: instantaneous

Preheating time: about 6 seconds.

Operating mode: continuous, unlimited

Fixed probe length: 20cm (7.87 inches)

Dimension: 22.9 cm x 6.5 cm x 6.5 cm (9.01 x 2.56 x 2.56 inches).

Electricity source: DC6V , 4 x AAA batteries(not included)"