Ceramic Tile Leveling System Replacement Steel Needle Replacement for6459
Wear-resistant, recyclable. Easy to use in DIY operation.
Balance tiles in the same horizontal position. Improve the installation speed of tile.
Reduce the fatigue/pressure of installers.
There is hardly any crackless, flat .
It reduces the need for grinding and polishing. Prevent tiles from moving during solidification.
Avoid not removing the T-tile leveling system
1. Ceramic tile gaskets are 2mm or more ( gaskets are recommended)
2. When leveling, the cement or tile adhesives around T-type leveller must be cleaned.
3. Remove the T-type straightener about 5-6 hours after leveling before the tile binder or cement is completely dried.
Type:Tile Leveling System
Use:100pcs Replaceable steel needle
Colour: Silver
Material: Stainless Steel
Size: Steel needle thickness: about 1.5mm, steel needle length: 32mm
Package Contents:
100 x Steel Needles
Use Tips:
Lay the first tile, leaving more than 2mm (with gaskets). Close to tile.
Insert T-pins along the slit between tiles.
Then rotate 180 degrees and the T-needle is stuck at the bottom of the two tiles.
Adjust the lid with a hand/special wrench until the two tiles are on the same level.
After leveling, about 5-6 hours, before the cement/binder is completely dry, rotate the lid in reverse and take out the 180 degree T needle until the word is removed.
Balance tiles in the same horizontal position. Improve the installation speed of tile.
Reduce the fatigue/pressure of installers.
There is hardly any crackless, flat .
It reduces the need for grinding and polishing. Prevent tiles from moving during solidification.
Avoid not removing the T-tile leveling system
1. Ceramic tile gaskets are 2mm or more ( gaskets are recommended)
2. When leveling, the cement or tile adhesives around T-type leveller must be cleaned.
3. Remove the T-type straightener about 5-6 hours after leveling before the tile binder or cement is completely dried.
Type:Tile Leveling System
Use:100pcs Replaceable steel needle
Colour: Silver
Material: Stainless Steel
Size: Steel needle thickness: about 1.5mm, steel needle length: 32mm
Package Contents:
100 x Steel Needles
Use Tips:
Lay the first tile, leaving more than 2mm (with gaskets). Close to tile.
Insert T-pins along the slit between tiles.
Then rotate 180 degrees and the T-needle is stuck at the bottom of the two tiles.
Adjust the lid with a hand/special wrench until the two tiles are on the same level.
After leveling, about 5-6 hours, before the cement/binder is completely dry, rotate the lid in reverse and take out the 180 degree T needle until the word is removed.
