- Condition: 100% new
- Color: Silver&Green&Yellow
- Material: Plastic & Metal
- Handle size: approx.10.3x3cm(4.1x1.2inch)(LxW)
- Sleeve size: approx.4.7x0.6cm(1.9x0.2inch)(LxID)
- Item included: 1 x Sleeve Tool
- Suitable for: 6mm anti-slip stud screw
This Is Aftermarket Replacement Item But Not Genuine
- Note:
1) All dimensions are measured by hand, there may be small deviations.
2) Color may vary slightly due to the color setting of each individual monitor.
Product Dimension:
Feature:
1) Simple hand tool, to easily install and remove the Anti-Slip tire stud screws.
2) Suitable for 6 mm stud screws.
How to install the tyre studs?
1) Put the car tire studs into the sleeve tool.
2) Drill (using a very small bit) down from the center of chosen knob into the tire.
3) Drill a screw up from inside-out. If the angle isn't perpendicular to the tire, it'll stick out one side or the other.
Do one hole and screw at a time. Don't try drilling all the holes, then installing screw.
4) Put duct tape over the screws on the inside of the tire; sometimes it is best to use two layers of tape.
