Digital Shore Durometer Gauge Measuring for Hardness LXD-A/C/D Portable Shore Hardness Tester

Introduction

Shore hardness tester is an apparatus to measure vulcanized rubber and plastic products. This apparatus has three models of Type A, Type C and Type D,Type A and D respectively are applicable to the testing of low and medium hardness, and high-hardness materials. 
Type C applies to the testing of microporous material which is used to make shoes, with compression rate 50 percent, stress 0.049 MPa or above, and this kind of material is made of rubber plastic and has blister in plastic.This hardness gauge conforms to the regulations of GB/T531, GB2411, HG/T2489, JB6148.

Main technical parameters

1.  Measuring range:0-100°

2.  Measuring error:Within 20-90°,the error is less than ±1°

3.Resolution:0.1°

4.Pressure Needle Range:0-2.5mm

5.End pressure of Pressure Head:Type A and C :0.55N-8.05N ;Type D:0-44.5N

Attention

Type A: applicable to general rubber, synthetic rubber, vulcanized rubber, soft rubber, leather, wax, etc.

Type C: applicable to the hardness test of rubber microporous material.

Type D: applicable to hard rubber, hard resin, acrylic, glass, cushiony plastic cement, printing plates, fiber, etc.


Note: The parcel will be sent without battery ,The battery type is 3V CR2032  environmental Lithium battery