NERDMINER V2 INSTALLATION MANUAL
1.Connect the USB-C cable and power on the Nerdminer.Use your phone to scan the QR Code displayed on the screen to connect to the Nerdminer's WiFi automatic ally.
2.The phone will automatic ally open the Nerdminer's setuppage.Click the "Configure WiFi"button.
3.Select the desired WiFi network you want to the Nerdminer tocon-nect to by choosing the SSID of the WiFi,and entering theWiFi pass-word in the"Password"field.
4.Paste your BTC wallet address in the "Your BTC Addresses"field.If you don't have a wallet,you can register to get one atwww.coinbase.com or any other Bitcoin wallet.
5.Enter your UTC time zone offset (wikipedia.org/wiki/List_of_UTC_off-sets),and then press "Save"to store thesettings.
6.After about 30 seconds,the Nerdminer will automatic ally restart,con-nect to the WiFi,and start mining.
GOOD LUCK!
TIP:Open a web browser on your computer or phone and enterthe lP address to check the mining status.
BUTTON PRESSES
-To modify the WiFi connection information or reset the machine,press and hold the button on the top for 10 seconds toperform a factory reset.
-Short press the button on the top to switch between three different sereens.
-Short press the button on the bottom to turn off the screen.