Incubator Controller Set Incubator Spare Parts Auto Egg Hatching Poultry 220V

Description:

Egg Incubator Mini Controller Set Incubator Spare Parts Auto Egg Poultry Hatching

Name: DIY Mini Incubator Accessories

Model: HTMC-5

Panel size: about 33.2*3*10.2cm/13.07*1.18*4.02in

Rated power: 80W

Rated voltage: 220V

Turn egg frequency: 2H/time

Temperature control range: 37 ° C 39 ° C

Scope of application: 48, 56, 96, 112

Packing size: about 34.8*7*14cm/13.70*2.76*5.51in

Parameters settings of temperature and humidity

1. Test: After connecting the components as shown in the figure, turn on the power, you will hear the alarm sound caused by the temperature and humidity, and manually cancel the alarm.

2. Set the temperature and humidity, change the number of hatching days: Press the SET button, press +/- to select the desired temperature, set the humidity and hatching days in the same operation (repeated twice), and finally press the setting to exit the setting. (Note: The factory setting is 37.8 °C, you can set 37.6 °C according to the above method. After setting the hatching days, the machine restarts.)

3. Low or high temperature alarm parameter setting: Press the setting button for 3 seconds, press +/-, the display screen will show AL, then press the setting button, press +/- to select the low temperature parameter. Press the setting button for 3 seconds, the display shows AH, and the high temperature alarm parameter is set as above.

4. Humidity alarm parameter setting: The humidity parameter is set at 45% when it is made and it does not need to be reset. (If you need to set it according to the temperature parameter setting mode, the display shows AS.)

5. Calibration of reporting of temperature sensor: The normal temperature reporting is set at 0 ° C. If it is not correct, the setting can be made. The method is the same as above, and the display shows CA. )

6. The upper temperature or the lower limit set: If HS (upper limit set) is set to 38.2 and LS (lower limit set) is 37.4, the original temperature can only be changed from 38.2 to 37.4, and the lower limit should be 37.2.

7. Heating element settings:The parameters HU and HD are set by the factory and do not need to be reset.as shown

Packing List:

1*electricity-powered fan

1*heated sheet

1*charging wire

1*panel

1*humidity be

1*temperature be

1*motor interface

1*egg motor