SP-POE-01 is an in-line RJ45 Ethernet Cat5e/6 surge protector with PoE (IEEE 802.3af) support. It simply installs in-line on an RJ45 Cat5e/6 cable. The arrestor has two RJ45 female jacks, but also comes with a short 5 inch male patch cord, so the in-line installation is a very easy and straight forward. It protects any Ethernet devices like switches, routers, laptops/PCs, etc from damaging surges caused by lightning or static electricity. Moreover, because of PoE feature it ALLOWS PoE enabled devices to remain powered while still protected against damaging lightning strikes or voltage spikes.

IMPORTANT
Two things are crucial and should NOT be missed when using the Ethernet surge protector:

- correct positioning: IN jack on the unprotected part of cable and OUT jack on the protected side of cable.
Reversed installation will still allow network traffic and operation but there will be no lightning/surge protection at all!

- proper grounding: please note the yellow/green ground wire. This wire must be connected to proper electrical ground in the building.
Ask a qualified electrician about such grounding or search the Internet for information.
Without proper grounding the surge protector will be unable to drain away the excess voltage and will be ineffective!


Features of SP-POE-01 Ethernet RJ45 surge protector
Fast energy absorption on over-voltage
Low resistance and minimal capacitance - minimal influence on data link
Easy in-line installation: two RJ45 female connectors and short 5" male 8 wire RJ45 patch cord

Technical specifications
Discharge current max.: 5KA
Discharge current nominal: 0.5KA
Max. voltage: 6.8V Data (pins 1,2,3 and 6) and 53V PoE (pins 4,5,7 and 8)
Response time: line-line<1ns, line-ground<100ns
Insertion loss: <0.5dB (100MHz)
Capacity: 40pF
Dimensions: 106.2mm x 37.6mm x 25.6mm
Weight: 75g


Thank you for looking!

---