HIGH QUALITY SIGNAL PRE- AMPLIFIER + 2 WAY SPLITTER
EASY DO IT YOUR OWN KIT, TAKES MINUTES TO INSTALL
COMPATIBLE WITH ALL TV AND OVER THE AIR ANTENNAS
32 dB GAIN
ADJUSTABLE GAIN OF 18 TO 32 db
This video signal amplifier is designed to extend the strength of signal line.
Why use a Pre Amplifier rather than a a regular Amplifier?
A regular Amplifier amplifies the signal where you install it on your system, so you loose Signal strength from your antenna to your house, where as a
Pre Amplifiers provide Gain Directly at the Source (antenna) therefor no loss of signal is experienced throughout the line.
You can run a longer Coaxial Cable, Multiple TV sets, without loss or reception quality.
The power Inserter in this package includes two outputs so you can optionally use it as a splitter as well.
Pre Signal Amplifier amplifies the VHF/ UHF (ANTENNAS) signal. This
amplification is necessary when a signal is sent through long lengths
of cable (50 ft. or more) or when the original signal is too weak to
produce a good picture at the receiving unit (TV/monitor or TUNER).
TV sets delivering snowy pictures? You could have signal loss due
to the length of cable or due to the number of splitters you are using.
Insert this amplifier into the coaxial line near your antenna or signal
source. This Amplifier will help you catch more channels if you are loosing signal due to low dB in your line.
COMPATIBLE WITH ALL HDTVs
UHF - VHF - FM
SIGNAL BOOSTER AMPLIFIER
HIGH DB GAIN ==== OVER 30 db GAIN
Bandwidth: 47-790MHz Gain Max: 18 To 32 dB Noise Figure: 1.5 dB Power: 12 Volts
This Amplifier is designed to amplify existing signals. It will not enhance a poor signal at source. This booster is not for SATELLITE TV. Note that We do NOT offer any kind of Guarantee in regards to receiving any extra # of channels in your set up, in fact if you use an incorrect amplifier and/or an amplifier that is not needed, you will loose channels partially or in Full. We sell this item "AS IS" and as experimental device. NO guarantee of any kind is offered.
Q & A:
1. I am missing a few channels that one of my friends has at his house, will I get those channels if I use this Amplifier?
A: Not Always, in Fact you may loose more channels if you use an amplifier that is not needed, the Excess noise will make you loose channels. it will only Help if you are loosing signal due to the resistance of your wire and other factor that may contribute to loss of Signal in your line.
2. Can I use this With Cable TV or Satellite TV?
A: No
3. I am using an amplifier that is 10 db and I want to Catch more channels, will this device help me achieve that goal?
A: Only if more amplification is needed, if you use excess amplification the excess noise will lower # of channels.
IMPROVE YOUR SIGNAL
PERFECT FOR RG6 CABLES RUNNING OVER 50 FT