![](https://www.mzfort.com/liqer/images/liqer_spc.jpg)
- Condition: 100% new
- Wire Color: Black & White
- Material: Metal & Plastic
- Diameter: Approx. 3.5cm(1.38 inch)
- Height: Approx. 2cm(0.79 inch)
- Effective surface of the knife: Approx.2.5cm diameter(0.98 inch)
- Cable Length: Approx.120m (47.24 inch), diameter 0.2 square feet
- Machine Type: Engraver Machine
- Control: CNC
- Power Source: Electric
- Suitable for: Rotary Tool
- Item included: 1 x CNC router engraving machine Tool
- Compatible With: fit for Mach 3 and many other CNC controller software
-
Only the above package content, other products are not included.
- Note:
1) All dimensions are measured by hand, there may be small deviations.
2) Color may vary slightly due to the color setting of each individual monitor.
![](https://www.mzfort.com/liqer/images/liqer_des.jpg)
Product Dimension:
Feature:
1) 100% Brand new and high quality.
2) CNC Z-Axis Tool Setting Touch Plate Probe Mach3 Router Mill.
3)CNC Router Engraving MACH3 Machine Tool Setting Auto-Check Instrument 35mm Dia.
4)CNC Router Mill Tool Setting Touch Plate.
5)CNC Z Axis Router Mill Touch Plate Mach3 Tool Setting Probe New Milling Hot Kit.
6)These touch plates make setting your tool height and zeroing your z-axis a breeze. These are fully functional in Mach 3 and many other CNC controller software.
7) Including alligator clips.
Usage:
1) The wire connect on the control panel interface.
2) The clip and the control board GND (negative) is connected.
3) The tool can be clamped portion of the operation when the knife with a clip.
4) When the tool contacts the knife that the process is complete.
Two Ways to Connect This Item:
If your interface board has the limit switch port or other probe port, you can connect it to that port.
If your interface board does not have that port, your driver board has that port, you can connect it to the driver board's limit switch port.
Then in the Mach 3, you need to setup the probe(Mach3 --- Config---Ports and Pins---Input signals Probe enabled , the pin number type the one you use) and the Auto-Tool-Zero.
![](https://www.mzfort.com/liqer/images/liqer_home_hmain.jpg)
![](https://www.mzfort.com/liqer/images/liqer_pic.jpg)