Frog Sounds HAM Radio QRP Kit Telegraph CW Transceiver Receiver Radio Station

Note : it is diy kit , Need soldering by youself 

This is a very small volume of a simple 40 meter band micro-power amplitude telegraph transceiver, 9V square battery or external 9-12V DC power supply. Spread good time, and the nearby provinces hundreds of kilometers amateur radio communications. This machine was first introduced by domestic radio enthusiasts, but also it played a nice name "frogs". The frogs calling Kit 3.1 public version based combined with the actual usage Fixed several key issues, after several debugging before the formation of the current version.

Key Indicators

Power supply: 9V-12V (Recommended 12V linear regulated power supply)

Antenna: 50 ohm, unbalanced

Transmission power: 2W (9V Power), 3W (12V power)

Frequency: transmitter local oscillator frequency: 7023 KHz; receive local oscillator frequency: about 7023-7026 KHz

Operating mode: CW

Use

This machine is simple direct conversion transceiver interference, selectivity can be compared and the super heterodyne receiver, it is necessary to use not worse than the length of a half-wave dipole antenna, or communication is relatively poor. The selection disturbance is relatively small; spread the good opportunity for communication experiment, it is best to make an appointment with your friend’s communication. Communication distance of about 150-300 km more secure, to greater distance depends on the propagation environment and the operator's operating skills. If the broadcast interference is relatively large, use 5K GAIN potentiometer signal attenuation, emergent signal from the radio interference. Attenuation potentiometer is critical, carefully adjusted; you will receive an unexpected effect. In the dissemination of good times with of this machine FT80C goods shortwave radio with a signal on a distant contrast reception, this local effect is no difference between basic commodity machine, which makes unexpected.

Recommendations for improvement

1N4001 replaced by appropriate varactor tube (recommended the 0P-100P), can increase the receive frequency range. Q1 9018 power between 0.8W ~ 1.2W 8050 power between 1.5W to 2W (select 8050 will make D882

In a critical state, need to be careful).

Package Contents :

Frog Sounds HAM Radio QRP diy Kit Telegraph CW Transceiver Receiver Radio Station V3

EBAY Managed Payment. But we only Accept your Ebay Address, please Make sure it's 100% right.
Payment must be received in 5 business days of auction closing.
Please leave note for your special request (e.g. Colors or Size) in PayPal when you pay the order.
Any special request cannot be accepted after 24 hours of payment, because most of orders will be processed instantly and same day dispatched.

1. We only ship to the confirmed address provided by eBay. please make sure your ebay address is 100% matches the address you would like us to ship to. If not, please let us know before we sent you the package, or we will not be responsible for any loss. hope you could understand.
2. Orders will be processed instantly and dispatched within 1-3 business days except hoilday, so we do NOT accept any email/message note after you place orders.
3. All package need to wait 30 days,Please take care it.Less than 30 days,we can't take a refund.

  • If you can't receive the product within 2 months (60 days), please contact with us,we promise to payback 100% of your money.
    We ensure our products work normally before post.If the products is broken before arrival to you,all you should do is taking a photo to show us our broken product.We promise to payback 100% of your money.

  • If the item is defect when you receive it or you are not satisfied with it, please return it within 14 days for a replacement or money back. But the items must be back in factory condition. Please contact us and double check the return address before you return it.
  • If is item is defective in 12 months, you can return it to us. We will send you a new replacement after receiving the defective item.

DataCaciques