Chevrolet 1936 - 1940

This is a metal brake line replacement kit. All lines are supplied double-flared at each end with S.A.E. specified male inverted flare fittings attached and are ready for quick and easy installation. All brake lines have an extra long nut on one end to seat in late model deep-seated wheel cylinders. These malleable lines are easy to bend or coil without collapsing the tubing or restricting the flow of brake fluid. Six couplers are included to join lines where necessary. Instructions are also included.

This kit contains all the lines to do a wide variety of Cars, and many different configurations, so you will have unused lines in any installation. These extra lines are a bonus that can be used for other projects

The tubing is double walled, seamless and copper fused with a special inner and outer coating to provide protection from abrasion and corrosion. This is the same tubing that is used on new cars!

All information on lines are for OEM brake systems only. However, this kit has many lengths and will service most modified system except any system with "smaller" 3/16 OD lines.

If you need a very sharp bend next to the flare at the end of the line, you will need a bender listed under "tools/supplies" on our eBay store.

All unions are solid brass to stop rust.

All lines are made in USA or Canada and are 1/4" outer diameter with a factory flare.

Due to improvements suggested by our customers, the kit may vary from the lengths listed above, but you will receive 21 steel lines.