T304 Stainless Steel Tube Reducer

A section of tube with each end swaged to a different ID to connect two different sizes of tube together.

Swage is 50mm deep.

All listings are swaged to internal diameter and will fit over the outside diameter of the same size.

Tube starts off at 1.5mm wall thickness; The swaging process stretches some of this material so the OD of the swage will be between 2mm - 2.9mm (Depending on size) greater than the listed ID.

1.5" - 2.5" Sections are 100mm long - 50mm deep swage may let the smaller section slide right through.

2.75" - 4" Sections are 150mm long. - The 50mm piece in the middle will block tube from sliding through.

2.5" - 3" Sections are currently 150mm long

These are prepped to be welded - but can be clamped once slotted. (We currently do not offer a slotting service.)