Description：

Santa Claus Kit

This DIY kit is designed as a cute cartoon characters of Santa Claus. It has 7 kinds of LED Colorful modes of the two full-color LEDs and 7 different Christmas songs. You can get rid of the power cord with only two button batteries CR2032 supply. You can make multiple "Santa Claus" while hanging on the Christmas tree to decorate your Christmas tree.You can also hang it on your body as a key pendant or as a mobile phone pendant, makes you look even more cool at Christmas day.

Features:

The red and white combination PCB board is designed as a cartoon Santa Claus image;

7 different Christmas songs (see the songs of list for details);

7 full color LED gradient effects;

The switch powers up automatically to switch to different led modes and different Christmas songs;

Can be set to turn music on or off;

Powered by two CR2032 coin cell batteries;

The kit is designed with DIP components for easy soldering;

Dual power supply available design;

PCB size: 76mm x 70mm;

(Note: The production process is in the description!)

The list of songs：

1, I wish you a merry Christmas;

2. Santa Claus Is Coming To Town;
3. When a child is born;

4, O Christmas Tree;

5. It Came Upon A Midnight Clear;

6, Joy To The World;

7, Jingle Bells;

DIY Santa Claus Christmas Tree Decoration Pendant Music Kit

Attention：

1. Soldering temperature must below 320 c, soldering iron temperature should not be too high, or they may damage the LED
2. When soldering LED,iron is the best grounding and it is best to wear anti-static bracelet soldering, soldering speed as quickly as possible

First solder the LED, the longest pin of the LED corresponds to the square pad insertion soldering

After the two LEDs are soldered, as shown below  

 solder 470 ohm resistor

solder 4.7K ohm resistor

Next, solder the IC, transistor, buzzer and switch.

Finally, solder the button battery holder. Please pay attention to the direction of the battery holder. The battery holder is placed and soldered as shown below.

If you don’t want to use the button battery power supply, there are positive and negative terminal pads on the board (connect 5V)

Finally, please use two CR2032 button batteries to supply power.

There is a lanyard hole on the circuit board, which can be hung with a rope. Doing a few hanging at home can increase the Christmas atmosphere.

Function:

1. Load two CR2032 button cells to supply power;
2. Toggle the power switch to switch to the next mode and the next song;
3. Turn the music switch to turn off or turn on the music;

5050 RGB LED Lamp Panel

100% Brand new and high quality!!

The control circuit and the LED share the only power source. Control circuit and RGB chip are integrated in a package of 5050 components, form a complete control of pixel point.

Built-in signal reshaping circuit, after wave reshaping to the next driver, ensure wave-form distortion not accumulate.

Built-in electric reset circuit and power lost reset circuit.

Each pixel of the three primary color can achieve 256 brightness display, completed 16777216 color full color display, and scan frequency not less than 400Hz/s.

Cascading port transmission signal by single line.

Any two point the distance more than 5m transmission signal without any increase circuit.

When the refresh rate is 30fps, cascade number are not less than1024 points.

Send data at speeds of 800Kbps.

The color of the light were highly consistent, cost-effective..

Applications:

Full-color module, Full color soft lights a lamp strip.

LED decorative lighting, Indoor/outdoor LED video irregular screen.

Specifications:

Color: black

Size: 5.3cm*1cm

Package includes: 1 x 5050 RGB LED Lamp Panel