Description:

1. Dry type acrylic bending machine/ heater is one new type linear acrylic bending heater. 2. It adopts thermal insulation, space insulation, shell cooling and automatic air-cooled and other technologies. It does not need water cooling and it can be operated after being plugged in. 3. It is easy to operate, environmentally friendly energy-saving, it can work 24 hours a day without maintenance. 4. It can be used alone or with the rack and backup plate. 5. It is one truly maintenance-free acrylic bending machine.

Specifications:

Product Name: Dry type acrylic bending machine/heater

Product Size: 1287mmX203mmX75mm

Bending width: ≤1220mm

Voltage: 220V / 110V

Maximum power: 800W

Rated Output: 500W

Heating groove width: 5mm

Cooling Type: Natural cooling / Automatic air cooling / Forced-air cooling

Net weight: 5.2 KGS (without power cord)

Packing Weight: 8 KGS

Packing Size: 1350x280x160mm

Package Included: 

1 x Power cord

1 x spare electric wire

1 x 300mm guiding rule

1 x 7mm handle sleeve 

1 x 3mm hex wrench

Instructions for use: 

1. The machine will produce some smoke from thermal insulation layer, please set Power regulator to 100 for few minutes after smoke disappear, then set power regulation around 45-65 according to operation situation.

Note：we also can remove smoke in our factory, but the heating area will have burn mark.

2. Please put the heating wire into the bottom of the heating groove if heating wire off heating groove or incorrect positioning and then operate machine

3. Adjust the ruler to 90° angle against linear heating groove

4. Plug Power cord in power outlet then the power regulation display light on, adjust it as 50-60 till heating wire to light red color

5. Put acrylic panel one side to guiding rule and align heating position at heating groove.

Waiting 20-30 seconds (May be different indoor temperature and machine setting) then the heating position soften to be bent, move acrylic panel away from machine and adjust bending angle on table.  The acrylic will take shape in few seconds.

6. Please unplug power cord after work.

7. The machine heater shell can be naturally cooled at 25℃ under rated power operation.

100% Heater power operation or ambient temperature is high and the case of heating temperature of the shell exceeds 50 ℃ ± 5 ℃, the heater will automatically open the air cooling and cooling device. 

When the temperature of the heater shell drops below 35 ℃ ± 5 ℃, the cooling device will be shut down automatically.

8. The handle sleeve and the hex wrench for heating wire replacement, please keep it properly.