eBay

1 pair (2 bulbs) of new SUPER bright high-quality LED bulbs.

They fit directly into your wiring harness sockets. They are non-polarity, so you just plug them in. No modification or fabrication to your tractor. It's as easy as changing a light bulb. They are brighter, last longer, use less volts, and will not melt your lens if kept on too long.

These modern LEDs replace older style single contact incandescent bulbs that are used in many tractors, snow blowers, and mowers. Please see pictures for bulb style and base style.

They are custom made and have a front projection lens, the beam angle is 360 degrees, a steel base, and an alloy body. One of the brightest bulbs in its class; over 2100 lumens each. However, it is the front projections that makes them so effective. They are better engineered than other bulbs.

Product parameters:
Features：COB four-sided lamp beads LED
Working voltage: 12VDC
Color temperature range: 6000K
Luminous color: white light
Peak luminous angle: 360°

Features:
1. Good sealing: waterproof, high temperature resistance, corrosion resistance;
2. High brightness: 10000-12000MCD;
3. Energy saving: 5W is equivalent to the brightness of 40W tungsten lamp;
4. Safety: 12V safety voltage, double insulation;
5. Longevity: The service life of the light source is 50,000 to 100,000 hours;
6. Simple installation: just replace the original car bulb directly.
7. It can be used as front and rear fog lights/brake lights/reversing lights/turn lights, etc.
8. The model is the same as the original car, no need to change the line, just replace the original car bulb.
9. There is no delay in lighting, and the response time is fast. Without filament structure, the vehicle control circuit is not easy to oxidize.
10. Low energy consumption, high brightness, higher cost performance.
11. Rich in color and pure color, DIY can be done at will, highlighting personalized lighting.
12. Cold light source, good comfort, belongs to the green environmental protection light source.

LED has the following characteristics and advantages:
1. Simple installation, plug and play, no need to change the line,
2.Energy saving, low power consumption, high luminous efficiency, low load current, now the oil is too expensive, 10% of the fuel consumption is used in car bulbs, switching to LED lights can effectively save fuel consumption and protect the car circuit.
3. Low fever, more conducive to driving safety.
4. The corresponding time is fast. The traditional light bulb needs to be warmed up and emits light. There is a 0.3 second delay. It can travel a distance of 4.4 meters at a speed of 40KM/hour and 0.4 seconds. LED lights, no delay. It can effectively prevent rear-end collisions. .
5.Strong shock resistance, no glass, tungsten wire structure.
6. Long service life
7. Pure color, bright color, high brightness

Installation Precautions:
The original car glass lamp is very hot. Please be careful when replacing it. The LED has positive and negative poles.

Install Caution：
1. As a safety precaution, make sure that the car has had time to cool down properly before starting the installation process.
2. Put the vehicle into park or make sure it is securely in gear.
3. Be sure to turn off the ignition and remove the key.
4. Be careful to avoid burns, especially when turning on or off the vehicles lighting.
5. Be careful to avoid crushing or cutting the bulbs. Also make sure to not touch the bulbs with your fingers, as this will cause blotting.
6. Fully examine the connection of the contact points, ports and the wires as faulty connections can cause lighting problems.
7. Make certain that the end of the bulb does not come in contact with the interior light shield of the headlight when adjusting the bulb.

Attention:
LED bulb is low power device, the following issues may occur if you want to use LED bulb on some European vehicles: Hyper Flashing, No Flashing, or Error Code. Those are NOT problems of LED bulb and NOT covered by warranty. You may simply add a set of load resistor (NOT included) to avoid those issues.can be solved with a decoder (decoder must be purchased separately)

If the product is not suitable or there is a quality problem, please contact our customer service directly to solve the problem. We will give you a satisfactory solution.

Store Category