PACKAGE CONTENT: ( NOT include Raspberry Pi board.)
7.5 inch e-Paper x1
e-Paper Driver HAT x1
Screws Pack x1
8Pin Jumper Cable x1
Wiki : waveshare.com/wiki/7.5inch_e-Paper_HAT_(B)
This is an E-Ink display HAT for Raspberry Pi, 7.5inch, 800X480 resolution, with embedded controller, communicating via SPI interface, supports red, black, and white three-color display.
Due to the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications such as shelf label, industrial instrument, and so on.
No backlight, keeps displaying last content for a long time even when power down
Ultra low power consumption, basically power is only required for refreshing
Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano
SPI interface, for connecting with controller boards like Raspberry Pi/Arduino/Nucleo, etc.
Onboard voltage translator, compatible with 3.3V / 5V MCUs
wiki English manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32)
Operating voltage: 3.3V / 5V
Interface: 3-wire SPI, 4-wire SPI
Outline dimension: 170.2mm × 111.2mm × 1.25mm
Display size:163.2 × 97.92mm
Dot pitch: 0.205 × 0.204mm
Resolution: 800X480
Display color: red, black, white
Grey scale: 2
Full refresh time: 16S
Refresh power: 48mW (typ.)
Standby power: <0.01uA (almost none)
Viewing angle: >170°
SYMBOL | DESCRIPTION |
VCC | 3.3V / 5V |
GND | Ground |
DIN | SPI MOSI pin |
CLK | SPI SCK pin |
CS | SPI chip selection, low active |
DC | Data / Command selection (high for data, low for command) |
RST | External reset, low active |
BUSY | Busy status output, low active |
Wiki : waveshare.com/wiki/7.5inch_e-Paper_HAT_(B)