This is an extremely easy-to-use connector for single color LED strip light. Even not professional, you can easily handle it. It can
be used as strip to strip connecting or re-joining cut strips.
For waterproof strip light: you need to sweep off the silicon first(be aware not to cut through the circuit board). Then open the connector and lock the strip under the plate.
For non-waterproof strip: just cut the strip as you need (cut every 3 LEDs), then open the connector and lock the strip under the plate.
Everything finished in a few minutes without soldering. BTW, make sure to match the positive(+) and negative(-) marks on both strips.If you feel there is a loose connection, thicken your strip light by adding an extra chip in between and make sure the built-in soldering point touches your strip light tightly.
Color:black+red
Single end connector
length:about 15cm
10 * 8mm single connector cable.