A fearsome sight, a band of blood-hungry, war Orc warriors heading your way 

These Orcs are printed in resin, unpainted, and inspired by the original 80's HeroQuest by Monstrous Encounters. 

The Orcs are modular, and hands and weapons are printed separately. Assembly is required. Due to some small parts, they may be left on supports for transport. 

The Complete Warband: a group of 11 Orcs is shipped with one of each weapon, item and one of each type of shield, with a few other left hands 
The Leader Pack: a group of 3 Orcs is shipped as in the picture. 
The Troop Pack: a group of 8 Orcs is shipped with one of each weapon, one of each type of shield and a few other left hands, 

Please message us after placing your order if you want a specific layout of items, such as swords, hands or shield types. 

These Orcs are also available individually.

They are ideal for any tabletop RPG, such as Pathfinder, Dungeons, and Dragons and table top war gaming. 

The models are available in three sizes (listed after the Model name in the dropdown): 

28mm - Ideal for use with the 80s version of Heroquest 
30mm - Ideal for use with the re-release (2021) version of Heroquest, Gloom Haven etc 
32mm - For the slightly more imposing size 

If you have any special requirements (such as a different size or a mirrored version), please don't hesitate to contact us, and we will see what we can do. 

We print each miniature to order; please allow up to 14 days for dispatch; we clean, cure, and prepare our minis by hand whilst we endeavour to make sure each is as perfect as possible. However, little evidence of the supports used during printing might still be visible. Models may require some tidying up as you would with any miniature and can be done so carefully with a sharp craft knife or fine sandpaper. Please take care not to breathe in any resin dust; if it is slightly sticky after cleaning up the model, then place it in direct sunlight until solid. Ensure you wash your hands afterwards as uncured resin can irritate. 

Some of the images used in these listings are 3D renders and are shown as a presentation of the final print. 

Though the resin is solid and resilient, it is not as strong as plastic miniatures. They may break from excessive force, such as being dropped. Please be aware that resin constantly cures when in contact with UV (such as sunlight); this can cause the miniature to become brittle over time. To protect it, you should prime, paint or coat it in a UV-blocking lacquer or varnish. 

We are a licensed reseller for Monstrous Encounters. You can find out more about their models via their Patreon: https://www.patreon.com/monstrousencounters/posts, or store on MyMiniFactory: https://www.myminifactory.com/users/Monstrous%20Encounters. If you want a Monstrous Encounters model printed and we have not listed it, please contact us to see what we can arrange.