Please view photos before you buy this item. 

Photos will describe condition of the item.

*Direct Plug-In Replacement.

* Warranty: 1 Year

* Built and tested to strict quality control standards

*4 & 5 wire configuration

Fitment:

2003-2006 Acura MDX 3.5L

2005-2008 Acura RL 3.5L

2004-2006 Acura TL 3.2L Auto Trans

2003-2007 Honda Accord EX - 3.0L Auto Trans

2003-2007 Honda Accord LX - 3.0L Auto Trans

2005 Honda Accord SE - 3.0L Auto Trans

2005-2007 Honda Accord Hybrid - 3.0L Auto Trans

2007 Honda Accord Special Edition - 3.0L Auto Trans

2005-2006 Honda Odyssey EX - 3.5L

2005-2006 Honda Odyssey EX-L - 3.5L

2005-2006 Honda Odyssey LX - 3.5L

2005-2006 Honda Odyssey Touring - 3.5L

2005-2008 Honda Pilot EX - 3.5L

2005-2008 Honda Pilot LX - 3.5L

2008 Honda Pilot EX-L - 3.5L

2008 Honda Pilot SE-L - 3.5L

2008 Honda Pilot Special Edition - 3.5L

2008 Honda Pilot Value Package - 3.5L

2006-2008 Honda Ridgeline RT - 3.5L

2006-2008 Honda Ridgeline RTL - 3.5L

2006-2008 Honda Ridgeline RTS - 3.5L

2007-2008 Honda Ridgeline RTX - 3.5L

2008 Honda Ridgeline EX-L - 3.5L

2008 Honda Ridgeline LX - 3.5L

Package Includes:

4 PCS Oxygen Sensor 

Must Know Before Buying:

• The following information is for instructional and guidance reference only. We try and make them as accurate as we can.
• If Check Engine Light is on or an OBDII Trouble/Fault code occurs after installation, check the sensor with a voltmeter as below. If the sensor is good, further diagnosis is required. There're many different codes for specific functional failures, which are NOT necessarily relevant to the sensor. Find out what the Code means before leaving any feedbacks.
• Items that have been installed, altered or contaminated are non-returnable. ONLY a defective sensor after tested by a voltmeter is applied to manufacturer warranty. 
• 20% restocking fee is required if buyer bought wrong items due to not paying attention to fitment information and ask for return.
• The Price, Quality & Funcitonality of the O2 Sensor is fully covered under our warranty & return policy. However, refund for any labor cost, expense in a dealer shop or damage due to wrong installation is NOT covered.
• 
  

Q: How do I know the O2 sensor is good or not? 

A: The only way to know if the O2 sensor is functioning normally is to check its responsiveness to changes in the air/fuel mixture, by Voltage Measurement or Waveform Simulation.

Use a 10-megaohm digital voltmeter. Hook up the voltmeter's red probe to the sensor's signal wire and the black probe to engine ground. (Use back probe method, DO NOT pierce the wire.) For a good sensor, voltage should fluctuate constantly between 0.1 and 0.9 volts after starting the engine for 2 or 3 minutes.

Please take a video clip of the voltmeter and contact us if our sensor:

• Goes above range between 0.1 and 0.9 volt
• Remains below 0.5 volts
• Stays fixed at a particular voltage

You're free to choose replacement or refund if our sensor fails to work, in this case.