basic skills |
VICTOR 9000E |
VICTOR 9000F |
|
Model distinction |
Fork type (which can be switched from different angles) |
Check type (switching from different angles) |
|
Features |
High-voltage AC current measurement, low-voltage AC current, online AC current monitoring |
||
power supply |
DC6V alkaline dry battery (1.5V AAA×4) |
||
test method |
Non-contact U-CT |
||
transfer method |
433MHz wireless transmission, the transmission distance is about 100 meters |
||
Display mode |
4-digit LCD display, backlight function, suitable for dim places |
||
LCD size |
47mm×28.5mm |
||
Instrument size |
Tester: 107mm × H 252mm × thick 31mm; Receiver: 78mm × H 212mm × thick 41mm |
Tester: Wide 210mm × Hight 246mm × thick 45mm; Receiver: Width 78mm × Hight 212mm × thick 41mm |
|
Jaw size |
φ68mm |
φ128mm |
|
Insulating rod size |
φ45mm, closed state 1150mm, extended state about 4500mm. |
||
Insulating rod voltage level |
110KV |
||
Sampling rate |
2 times/sec |
||
Measuring range |
0.00A~9999A (50/60Hz automatic) |
||
Resolution |
0.01A |
||
Change files |
0.00A~9999A fully automatic gear shift |
||
Test accuracy |
±2%±5dgt (The wire is located near the center of the bottom end of the U-shaped jaw, 23℃±2℃) |
||
Position error |
The wire under test should be as close as possible to the center of the bottom end of the U-shaped jaw |
||
data storage |
99 groups, the "MEM" symbol indicates during the storage process, and the flashing display of the "FULL" symbol indicates that the storage is full |
||
Line voltage |
Test of bare wires below 60kV (operation with insulating rod, fully extended telescopic insulating rod) |
||
Data retention |
In the normal test mode, press the HOLD key to keep the data, the "HOLD" symbol is displayed, and then press the HOLD key to cancel |
||
Data access |
The "MR" symbol indicates that the stored data can be flipped up and down |
||
Overflow display |
Over-range overflow function: "OL A" symbol display |
||
No signal indication |
When the receiver does not receive the transmitted signal, the "no- -" symbol is displayed dynamically |
||
Automatic shut-down |
About 15 minutes after power on, the meter will automatically shut down to reduce battery consumption |
||
Instrument quality |
Detector: 235g (including battery), receiver: 280g (including battery, total mass of the meter: 2300g (including insulating rod and battery) |
||
Working temperature and humidity |
-10℃~40℃; below 80%Rh |
||
Interference |
Try to avoid 315MHz, 433MHz co-frequency signal interference |
||
Dielectric strength |
AC 220kV/rms (the telescopic insulating rod is fully opened, between the two ends) |
||
Random accessories |
Clamp meter: 1 piece; receiver: 1 piece; telescopic insulating rod: 1 piece; battery LR03: 8 pieces; cloth bag: 1 piece |