3Pcs Fuel Injector Sleeve Cup Remove Install Puller for 2003-2010 Ford 6.0L 6.4L
Fitment:
Works on All 2003~2010 6.0L and 6.4L Engines
Features:
1) Advanced blackening hard steel process, durability, ultra-precise design meets the requirement of high precision and hardness and a much longer service life.
2) The separate tap could be replaced at any hardware store at minimal cost if it wears out or breaks. The shortness of the tool allows this to be done in the engine compartment very easily.
3) When diesel fuel in the cooling system caused by a crack in one of the cylinder heads, the cylinder heads need to be removed from the vehicle in order to replace the sleeves, this injector sleeve remover / installer tool set makes this repair a relatively easy job and allows replacement of the injector sleeves / cups without removing the heads from the vehicle.
4) The tap is separate from the puller portion of the tool, you may purchase an inexpensive tap at the local hardware store. By installing this 6.0 Powerstroke injector cup tool, you'll also need an o-ring( provided by head repair kit )to retain the injector sleeve to the installer.
INSTALLATION INSTRUCTION
1.Thread the 'Tap' portion into the injector cup then crank the bolt down.
2.Put the removal it into the injector cup and holds them onto the cup, then tighten the nut on the tool to pull the cup out.
3.Place the injector cup over the end of the installer then place it back into the injector hole and hammer it until you hit solid ground.
Package included:
1x Electrical Connector Remover Tool,
1x Sleeve Installer,
1x Puller