Function:
- OE replacement Mercury/Mariner Ignition CDM Module
- OE #114-7509, 827509A 1, 827509A 3, 827509A 4, 827509A 7, 827509A 8, 827509A 9, 827509A10, 827509T 7, 9-23202, AMW-3454
- Fits engines: Mercury (1996-2007 (30-300HP) Force (1996-1999 (40,50,75,90 & 120HP)
- This product is designed for installation by a professional marine mechanic
Fitment:
- Fits 30 HP 2 cylinder engines from 1996 to 2006 with serial number range 0G380075-0T979999
- Fits 30 HP 3 cylinder engines from 1998 to 2001 with serial number range 0G590000-0T999999
- Fits 40 HP 2 cylinder engines from 1996 to 2005 with serial number range 0G380075-0T999999
- Fits 100 HP 4 cylinder engines from 1996 to 2000 with serial number range 0G438000-0G965520
- Fits 200 HP 6 cylinder engines from 2000 to 2005 with serial number range 0G960500-1B226999
Part Number:
114-7509
827509A3
827509A4
827509A7
827509A8
827509A9
827509A10
827509T7
How to install ignition CDM module 114-7509 ?
1. Disconnect and clean all engine and battery ground wires
2. Disconnect the old CDM Module and remove the high tension coil wire from the spark plug
3. Unbolt and remove the old CDM Module. (Note the direction of the spark plug wire)
4. Check for dc voltage on the kill (stop) wires (usually black/Yellow) with the key switch in the on and off position.
5. Apply a slight amount of dielectric grease to the seal area of the wire connector from the engine harness
6. Apply a slight amount of dielectric grease to the outside of the new spark plug wire and thread the spark plug wire into the new CDM Mod
7. Bolt the new CDM Module onto the engine(orient the new CDM Module so that the spark plug wire is pointed in the same direction as the original)
8. Plug in the connector from the wire harness into the new CDM Module and connect the spark plug wire to the spark plug